How to Use BMW ICOM B for initial Use ?

Before flashing anything with a new ICOM-B for the first time, I recommend doing a stress test with Tool32.

Configure Ediabas to most async ab 625, open Tool32 and cicr.prg.

Then select job fs_lesen

and then from Tool32 top bar, select “play”.

This will make the “read error memory” job run on repeat.

If it can do it for 30-60 minutes, then the head is probably ok.

Obviously the BMW ICOM emulator must be connected to the CIC.
When you make a flashing , you can confirm data communication in task managers.

And, ICOM B, green flashes on and off.

How to Read LED info from ICOM B:
The ICOM B includes a (2) two LED display. These LED|s displays the following information and warnings:

1.One 2-color LED label SYSTEM for the general status:

Off ——————————– no power or problems with power supply

Yellow —————————– initializing ICOM B

Red flashing ———————- problems with booting/initializing

Green —————————– ready

Green flashing ——————– communication

2.One 2-color LED label MOST for the status of MOST communication Ethernet:

Off ——————————— no light at MOST

Red ——————————– no lockable light

Green ——————————stable LOCK

Yellow *—————————- no stable LOCK

* Yellow = the relevant LED lights up simultaneously red and green.