Autel MaxiSYS Pro MS908P Key Erase Issue on 2000 Ford Focus (fixed)

---

Write this blog to share my problem about Maxisys Pro MS908P key erasure on 2000 ford focus and its solution with you

2000 Ford Focus Z-Tech Diagnostic tool used:

Autel MaxiSYS MS908P Issue description:

I intended to replace the PCM in my vehicle With followed all the instruction for key erasure, the Autel Scan Tool MS908P seemed to freeze at the 9 second make on the task bar

Reasons:

The engine told me that I could only program new third key with having 2 already programmed keys, which meant that I couldn’t program new key if I did not have 2 working Keys

Solution:

1.Download the beta version V6.12.10 to have a test.

2.Try to program key manually. The process bar will appear for 10s after key erasure. Please ignition off and program it as followed

Turn the ignition key to position 0

Cycle keyl in the ignition from OFF to RUN for at least 3 seconds

Cycle key2 in the ignition from OFF to RUN for at least 3 seconds

Cycle keyl in the ignition from OFF to RUN for at least 3 seconds

Two keys are programmed now

http://obd2trade.com/2017/11/28/autel-maxisys-pro-ms908p-key-erase-issue-on-2000-ford-focus-fixed/